You are here：West Lake Grinding Wheel Factory > News > Technical Support > Maintenance method of polishing machine
Maintenance method of polishing machine
Maintenance method of polishing machine
West Lake polishing machine maintenance methods, please look at the following points:
1, each run out, we must take the polishing pad, so as to prevent damage to the polishing pad;
2, the machinery to maintain the backward tilt, the rear wheel must be stored in the ground;
3, after use, it is best to use hot water to clean the polishing pad;
4, clean up the base in a timely manner, wipe clear polish and dust, dirt;
5, power line requirements, good storage, must be wrapped in the suspension hook, reoccupy wet dishcloth wipe surface layer of power line, if it is found that the power cord is damaged, to timely replacement, and can not be re used.
6, after use without the use of lubrication oil, high-speed polishing machine gear, the motor drive system before they leave the factory had to do lubrication work in this area;
7, every month it is best to check the drive belt tightness, adjust the drive belt first take the polishing pad driver, then loosen the polishing pad drive pulley rack screws, finally find the drive belt tightness of the bolted, adjust the elastic degree;
8, check high-speed polishing machine motor carbon brush wear, if it is found that the more wear, timely replacement, ensure polishing effect is the best.
Because there are many varieties of polishing machine, maintenance methods are not the same, there is any doubt, please call advisory!
West Lake polishing machine maintenance methods, please look at the following points:
1, each run out, we must take the polishing pad, so as to prevent damage to the polishing pad;
2, the machinery to maintain the backward tilt, the rear wheel must be stored in the ground;
3, after use, it is best to use hot water to clean the polishing pad;
4, clean up the base in a timely manner, wipe clear polish and dust, dirt;
5, power line requirements, good storage, must be wrapped in the suspension hook, reoccupy wet dishcloth wipe surface layer of power line, if it is found that the power cord is damaged, to timely replacement, and can not be re used.
6, after use without the use of lubrication oil, high-speed polishing machine gear, the motor drive system before they leave the factory had to do lubrication work in this area;
7, every month it is best to check the drive belt tightness, adjust the drive belt first take the polishing pad driver, then loosen the polishing pad drive pulley rack screws, finally find the drive belt tightness of the bolted, adjust the elastic degree;
8, check high-speed polishing machine motor carbon brush wear, if it is found that the more wear, timely replacement, ensure polishing effect is the best.
Because there are many varieties of polishing machine, maintenance methods are not the same, there is any doubt, please call advisory!
