- Dust removal grinder (standard)
- Dust removal grinder (automatic vibration ash type)
- Dust removal grinder
- Dust removal grinder (economy)
- It drive type grinding machine
- floor stand grinder
- Vertical grinding machine
- Economic grinder
- Hand-held (straight) grinding machine
- Hand push type grinder
- Side grinding wheel
- Marine sand turbine
- Grinding head
- Belt sander
- Dust type abrasive belt grinding machine
- Hand push Belt sander
- buffing machine
- Dust polishing machin
- section steel cutter
- Dust type profile cutting machine
- Dust environmental protection equipment (ESP)
- Automatic grinding machine grinding machine
- Industrial drilling machine series
- Marine drilling machine
- Drilling tapping machine series
- Drilling and milling machine series
- Automatic feed drilling machine series
- Series of tapping machine
You are here：West Lake Grinding Wheel Factory > Products > Hand-held (straight) grinding machine > Suspended sand wheel
Suspended sand wheel
Safety operation regulations for suspension of a hand-held sand turbine
1, before use to check whether the firm hanging object.
2, the first use, first observe whether the motor is turned over, under normal circumstances, the grinding spark is to the motor direction of injection, and vice versa, should be immediately shut down check circuit is normal.
3. After starting the grinding wheel machine, the grinding wheel should be carried out after the rotation of the turbine. If the sand turbine is obvious, it should be stopped in time.
4, grinding force should not be too large.
5, according to the use of the manual wheel, grinding wheel and grinder spindle speed match.
6, the new leader of the grinding wheel to have a factory certificate, or check test marks. If the quality of the grinding wheel is found, the quality of the grinding wheel, the hardness, the size of the grain and the appearance of the cracks are not used.
7, the installation of grinding wheel, the inner hole of the grinding wheel and the main shaft with the gap should not be too tight, should be loosened with the technical requirements, the general control between 0.05/FONT>0.10 mm.
